Hinkley Lighting DILLON 3662BN - Manual

assembly instructions
item No. 3662
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. Thread center stem (2) into the coupler (E), located in the center of the pan assembly - see
Drawing 3.
2. Thread hex nut (3) up against coupler (E) to secure center stem (2) in place.
3. Thread hex nut (4) onto center stem (2) until it is 1- 3/8” from the end.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction sheet (I.S.
18) and follow all instructions to make all necessary wiring connections.
*** The construction of this fixture will be accomplished by first assembling the main body of
the fixture, installing the mounting bracket, making all necessary wiring connections, mount-
ing the fiture to the ceiling, and then installing the glass.
star t here
3662
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 2 - Fixture Mounting
Drawing 3 - Glass Installation
Drawing 1 - Strap Detail
6
J
B
A G
D
E
C
1. Prepare mounting strap (B) for mounting by installing screws (A) into mounting plate (B) - see
Drawing 1.
• Be sure the holes into which the screws are threaded match the spacing of holes (C)
in the canopy (1) - see Drawings 1 and 2.
2. Attach mounting plate (B) to junction box (J), using screws (G) provided and slip supply wires
through large center hole.
1. Hang the fixture by slipping canopy (D) over screws (B) and hold in position - see Drawings 1 and
2. Thread ball knobs (E) onto end of screws (B) and tighten to secure fixture to ceiling.
6.1.12
1
2
7
5
3
4
6
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, Ohio 44012 800-446-5539 www.hinkleylighting.com
1. To install glass, slip center hole of glass (4) onto locator disc (3), located at the
base of the adjustable center stem (2), of the cental assembly (1). Hold glass in
position - see Drawing 3.
2. While holding glass (4) slip cap (5) onto center stem (2) and hold in postion.
3. Thread on hexnut (6) onto center stem (2) and thighten to secure glass to fixture.
4. Slip decorative cap (7) onto center stem.
5. thread knob (8) onto end of center stem (2) and tighten to complete assembly.
8