Hinkley Lighting HAMPTON 3217AN - Manual

assembly instructions
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembl y .
*** The construction of this fixture will be accomplished by first assembling the
main body structure, installing the mounting hardware to the junction box, hanging
the fixture from the ceiling and then installing the shade.
start he re
3217
Drawing 1 - Fixture Assembly
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Family: Hampton Item No. 3217
A
1
1
2





















































































































01.01.12
SHADE REMOVAL
1. To remove shade from fixture for cleaning or replacement it will be necessary to remove one
of the arms (A). This is accomplished be removing screws (1) from the top of the arm and at the
bottom of the arm - see Drawing 1.
2. After screws are removed pull arm (A) staright away from the center of the fixture. Do not bend
or twist.
3. Shade (2) can be removed by lifting the shade and tilting it so it be slipped out.
4. New or cleaned shade can be replaced in the same fashion by tilting and lifting back into the
fixture.
5. Slip arm (A) removed earlier back onto tabs (B).
6. Replace screws (1) to secure arm to fixture.
1. To install fixture follow instructions sheet (IS-19) provided.
2. After installation fixture can be lamped by lifting the shade upward and reaching in from
bottom of shade to insert light bulbs.
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com