Hinkley Lighting MERIDIAN 3875SK - Manual (Page 2)

1. Shut off electrical current before starting. If the fixture you are replacing is
turned on and off by a wall switch, simply turn the switch off. If not, remove
the appropriate fuse (or open the circut breakers) until the fixture is dead.
• DO NOT restore current - either by fuse, breaker or switch - until the new
fixture is completely wired and in place.
1. Determine the desired height the chandelier will be installed at.
2. The fixture is supplied with a variety of stem lengths. Determine what combination
of stems are needed to achieve desired length - see Drawing 1.
3. Slip stems over wire and thread first stem onto top of chandelier. Repeat this process
until all required stems are threaded together.
4. Slip wire through center of canopy swivel and thread onto stem assembly.
start here
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. Thread two long 8-32 (1) screws provided into the mounting strap (2).
Note: the two screws should be threaded into the gull wing shaped part of the
mounting strap with the flat part of the strap facing up. Make sure screws are threaded
into holes that line up with the holes in the canopy (3) - see Drawing 2.
2. Attach mount strap (2) to junction box with two short 8-32 screws (5) provided.
3. Make wire connections following the instructions on I.S.18 instruction sheet provided.
4. Slip canopy/fixture over screws (1) and secure fixture with ball knobs (4).
Drawing 1 - Fixture Assembly
Drawing 2 - Fixture Assembly
I.S.19-90
hanging instructions
I.S
. 19-90
1
2222
2223
25
4
stem
wire
wire
wire
junction box
stem
3
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com