Hinkley Lighting THISTLEDOWN 4171VZ User Manual

Start here, Assembly instructions

Advertising
background image

assembly instructions

Family: Thistledown Item No. 4171 VZ

1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.

*** The construction of this fixture will be accomplished by first assembling the
main body of the fixture, making all necessary electrical connections, mounting
the fixture to the ceiling, and then installing the glass.

start here

41

71

1. To install glass, slip glass (3) over nipple (2) and hold in place. - see Drawing 1.

2. Slip washer (4) onto nipple (2) and thread on knurl nut (5). Hand tighten only.
Note: Using a tool to tighten knurl nut could cause damage to the glass.
3. Slip cap (6) onto nipple (2) and thread finial (7) onto end of nipple (3).
4. Fixture can now be lamped accordingly.

Drawing 3 - Fixture Mounting

Drawing 2 - Strap Detail

B

(side view)

gull wing

bracket

B

1

8
2

Drawing 1 - Fixture Assembly

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.

1. Prepare gem strap (A) for mounting by threading two screws (B) provided into
back of gull wing bracket of gem strap (A) - see Drawing 2.
Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the canopy (E) - see Drawings 2 and 3.
2. Mount gem strap (A) to junction box (J), using the two 8-32” screws (C).

1. Mount the fixture by slipping the holes (D) in the mounting plate, over the screws
(B) in the mounting strap - see Drawing 3.
2. Thread on ball knobs (F) onto the end of the mounting screws (B) to secure fixture
to the wall.

1. Take main body assembly (1) and thread center nipple (2) into coupler (8) - see
Drawing 1.

5

6

4

6

5

3

7

2.7.08

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

Advertising