Hinkley Lighting AVA FR42872VBZ - Manual

ASSEMBL Y INSTR U CTI O NS
The construction of this fixture will be accomplished by first assembling the main body
of the fixture, making all necessary electrical connections, hanging the fixture from the
ceiling and then installing the fixture shade.
SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
FR42872vbz
AvA
STEP 1
1 Prepare mounting strap (a) by threading the two long mounting
screws (b) into the back of the mounting strap (a), making sure the
holes into which the screws are threaded match the spacing of holes
(d) in the back plate (e) -- See Drawing 1.
2 Attach mounting strap (a) to junction box (j) using two screws (c).
3 Make electrical connections from supply wire to fixture lead wires.
Refer to instruction sheet [FRIS18] and follow all instructions to
make all necessary wiring connections. Then refer back to this sheet
to continue installation of this fixture.
4 To mount fixture, slip the two mounting screws (b) through the two
mounting holes (d) in the back plate (e).
5 While holding fixture in place, thread the two ball knobs (f) on to the
end of the mounting screws (b), and tighten.
STEP 2
In order to install the shade correctly make sure the notches are in the
upright position. To install the shade slide shade cross bar (A) into
shade notch (B). -- See Drawing 2
STEP 3
Slide the cage into overtop of the shade and fixture body and thread the
screw into place in order to lock the cage in place. – See Drawing 3
Bulbs:
60W CAND .