Hinkley Lighting OMNI 57203PN - Manual

assembly instructions
Item No. 57203
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. Remove barrel knobs (C) from fixture - see Drawing 1.
2. Reomve retainer plate (A) from backplate (D).
3. Attach retainer plate (A) to junction box using 2 screws (B).
4. Additional wall anchors supplied can be installed at keyhole points (E).
1. Slip holes (G) in backplate (D) over screws (F) on retainer plate (A).
2. Thread barrel knobs (C) onto end of screws (F) and tighten to secure backplate.
*** The construction of this fixture will be accomplished by first mounting the
mounting strap to the junction box, making all necessary electrical connections,
mounting the fixture to the wall and then installing the fixture glass.
start here
57203
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 1 - Mounting Detail
Drawing 2 - Glass Installation
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to complete installation of this fixture.
5
6.1.11
B
A
C
D
F
G
E
wall
anchor
anchor
screw
junction
box
Note: Fixture should be lamped accordingly at this point before installing
the glass.
1. To install glass, slip glass (4) over socket (3).
2. Slip spacer (2) over socket (3) inside the glass (4).
3. Thread bulb shield (1) onto socket (3) and tighten by hand until snug against
spacer (2) to secure glass. Do not over tighten.
install
lamp
before
installing
glass
3
2
1
4
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 44.653.5500 hinkleylighting.com