Hinkley Lighting NEW CASTLE 2252 - Manual

assembly instructions
Item No. 2252
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling
main body of fixture, making all necessary electrical connections, hanging the
fixture from the ceiling, and then installing the glass.
start here
2252
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer to instruction sheet (I.S. 19) for hanging instructions. Then refer back to
this sheet to continue installation of this fixture.
1. Slip loop (L) along wire and thread onto stem (A) and tighten.
Drawing 1 - Fixture Assembly
01.01.13
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
2. Fixture can be installed prior to installing glass. Follow mounting instructions provided.
R
G
1
2
3
1. Lamp fixture with GU-10 lamp prior to installing the glass, and lossen barrel knobs,
with studs (2) to allow glass lip to fit in glass fitter (G) of main body (1).
2. Slip glass (3) through bottom ring (R) of fixture. Making sure lipped end is up.
3. Lift glass, till lip of glass (3) is properly seated in glass holder (G), hold glass in
position and thread in barrel knobs with studs (2) to secure glass. Do not use a tool to
tighten barrel knobs, over tightening could damage glass.
2