Hinkley Lighting CAMDEN 3344CM - Manual

- 1 -
____ Assembly Instructions ____
start here
1. Find a clear area in which you can work.
2. Unpack Fixture and glass from carton.
3. Carefully Review Instructions Prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the
stems to the main body, attaching the mounting strap to the junction box,
making all necessary electrical connections, hanging the fixture from the
ceiling, installing the shade, and then installing the glass lens.
Drawing 2 – Glass Installation
SAFETY WARNING: READ WIRING AND GROUNDING
INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS.
TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW
WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR
LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 1 – Mounting Detail
1. Determine the desired height the chandelier will be installed at.
2. The fixture is supplied with a variety of stem lengths. Determine what combination
of stems are needed to achieve desired length - see Drawing 1.
3. Slip stems over wire and thread first stem onto top of chandelier. Repeat this process
until all required stems are threaded together.
4. Slip wire through center of canopy swivel and thread onto stem assembly.
stem
wire
wire
wire
stem
Drawing 1 – Stem Installation
3344
01.01.13
1. Fixture is ready for installation. Please follow instruction sheet (IS19-91) to
continue assembly.
2. Return to this section of the instruction sheet for shade and glass installation.
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
Family: Camden Item No. 3344
2
A
1. Thread hex nut (2) onto one end of center stem (3).
2. Thread stem (3) approximately 3/8” into coupler (A), located in the center of ceiling
pan (1) - see Drawing 3.
3. Thread hex nut (4) onto end of center stem (3) unitl approximately 3/8” from end.
4. Slip glass support cap (5) onto center stem (3), and hold in position.
5. Slip glass (6) center hole over center stem (3).
6. Thread decorative cap (6) onto end of center stem (3) and tighten to secure
glass (6).