Hinkley Lighting CHESTERFIELD 1385 - Manual

assembly instructions
Item No. 1384 / 1385
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first mounting the
mounting strap to the junction box, making all necessary electrical connections,
mounting the fixture to the wall and then assembling the main body of the fixture.
start here
1385
Drawing 2 - Fixture Assembly
01.01.13
Drawing 1 - Fixture Mounting
E
F
D
C
A J
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. To mount fixture, slip the two mounting screws (B) through the two mounting holes
(D) in the backplate (E) - see Drawing 1.
2. While holding fixture in place, thread the two ball knobs (F) on to the end
of the mounting screws (B), and tighten.
1. Prepare mounting strap (A) by threading the two long mounting screws (B)
into the back of the universal strap - see Drawing 1.
• Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the back plate (E).
2. Attach mounting strap (A) to junction box (J) using two screws (C) provided.
5
B
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 44.653.5500 hinkleylighting.com
1. To complete assembly of fixture, first thread bottom center tube (1) [beaded end up]
into bottom of socket assembly (G).
2. Slip candle sleeve (2) over socket (S).
3. Fixture can be lamped accordingly at this time.
4. Slip glass (3) into decorative cage assembly (4) making sure glass rest in ring (R).
5. Slip glass (3) and cage assembly (4) onto bottom center tube (1) making sure glass
rest inside top ring (T), hold in position and thread on hex nut (5) and tighten to secure
glass and cage assembly to fixture.
6. Thread on decorative bottom knob (6) and tighten to complete assembly.
1384
T
R
S
G
1
2
3
4
5
6