Hinkley Lighting KUBE 1761 - Manual

assembly instructions
Item No. 1761
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
.
start here
1761
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
Drawing 1 - Installing top lamp
*** The construction of this fixture will be accomplished by first lamping the
fixture making all necessary electrical connections, and then mounting the
fixture to pre-installed post.
01.01.13
1. To install top lamps remove the 4 phillip screws (1) from top of fixture
- See Drawing 1.
2. Lift lid (2) and locate socket (A).
3. Take GU-10 lamps provided (B) and slip pins into socket (A)
and rotate bulb to
lock it in position.
4. Replace lid (2) of fixture .
5. Fixture is ready for installation.
Drawing 3 - Fixture installation
1. After wiring connections are complete, slip post fitter (F) over top of pre-installed
post (D) making sure all wire connections are tucked inside the pole - see Drawing 3.
2. When fixture is slipped over pole make sure no wires are being pinched between
the top edge of the pole and the inside of the post fitter.
3. Thread the 3 set screws (E) into pre-tapped holes in post fitter.
4. Tighten set screws (E) with allen wrench provied to secure fixture to post.
ground wires
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
Drawing 2 - Glass Replacement
B
D
E F
A
1
2
3
4 5
4
GLASS INSTALLATION OR REPLACEMENT: please follow the instructions below:
1. Remove top lid from fixture as described in Step 2.
2. Unthread barrel knob (3) from the side of the fixture and remove clip (4).
3. Remove / install glass (5) in fixture and slip glass in place, making sure
bottom of glass fits into tabs at bottom of fixture.
4. Replace glass clip (4) and thread barrel knob (3) back in place to secure glass and clip.
4. Replace fixture lid.