Hinkley Lighting HOLBROOK 1792 - Manual

assembly instructions
Item No. 1792
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling
main body of fixture, making all necessary electrical connections, hanging the
fixture from the ceiling, and then installing the glass.
start here
1792
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer to instruction sheet (I.S. 19) for hanging instructions. Then refer back to
this sheet to continue installation of this fixture.
1. Slip loop (L) along supply wire and thread onto stem (A) and tighten - see Drawing 1.
Drawing 1 - Fixture Assembly
01.01.13
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
4
3
1
2
Drawing 2 - Glass Installation
2. To install glass panels (2), slip them up through the open bottom of the cage (1).
- see Drawing 2.
3. Slip bottom of glass panels (2) into channel (3) in bottom of cage (1) tip top of panel
into position, and bend over clips (4) down to secure glass in cage. Repeat procedure
for remaining panels of glass.
1. To complete assembly lamp fixture accordingly.