Hinkley Lighting HARBOR 2576 - Manual

assembly instructions
Family: Harbor Item No. 2576
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. To install mounting bracket, determine location where mounting bracket is to be
mounted to pier, and mark hole location. - see Drawing 1.
2. Drill 3/8” diameter hole, 1-3/4” deep with a masonry drill at marked locations.
3. Tap mounting bolts (1) with sleeve into drilled holes, sleeve end first.
4. Place mounting bracket (2) over bolts.
5. Place washer (3) followed by lockwasher (4) onto all of the bolts.
6. Thread hex nut (5) onto bolts and tighten.
Note: Bolts provided are for mounting in concrete or stone. If mounting to any other
type of material use an appropriate fastener.
1. To lamp fixture or replace glass, remove the two ball knobs (7) from under the roof
(8) - see Drawing 2.
2. Lift roof (8) off of fixture.
3. Fixture can now be lamped accordingly.
To replace glass: unscrew round head screws (9) and remove upper half of main body
(10). Glass can now be replaced. Then replace upper half of main body (10) and secure
with round head screws (9).
4. Replace roof (8) and thread ball knobs (7) onto fixture.
*** The construction of this fixture will be accomplished by first installing mounting
bracket to pier, making all necessary electrical connections, mounting fixture to pier
and then lamping fixture accordingly.
start here
2576
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 1 - Fixture Mounting
Drawing 2 - Fixture Assembly
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections. Then
refer back to this sheet to continue installation of this fixture.
2
2
1
1. To mount fixture to bracket, slip base of fixture over mounting bracket, making sure
that the screw holes on the side of the base and the ends of the mounting bracket
line up - see Drawing 2.
2. Slip flat head screw (6) through the base and thread into mounting bracket.
5
12.1.09
6
7
10
9
8
3
4
5
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com