Hinkley Lighting REVERE 1180SN - Manual

Drawing 2 - Assembly
star t here
1. To install glass, open side door (not shown on drawing 2) of fixture by lifting up on
the small wire tab located on the right side of the fixture when looking at it straight on
- see Drawing 2.
2. Install small panel of glass (1) on left side of fixture by slipping the glass into the
cage through the door opening (2) at a slight angle and around the socket (3) and into
position.
3. Fold glass clips (4) located at the top and bottom of the cage so they contact the
glass and hold it in position.
4. Repeat procedure for front and back large panels of glass. Starting with the back
panel.
5. When all glass panels are installed, the candle sleeve (5) can be slipped over socket
(3).
6. Fixture can now be lamped accordingly.
assembly instructions
1180
2
3
4
5
Note: Maximum wattage for 1180 fixture is 60 watts per bulb.
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first installing the
glass, mounting the mounting strap to the junction box, making all necessary
electrical connections, and then mounting the fixture to the wall.
Family: Revere Item No. 1180 SN
6.1.10
5
1
3
2
4
Drawing 1 - Fixture Mounting
E
B
F
D
C A J
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
1. Prepare mounting strap (A) by threading the two 1 1/4” long mounting screws (B)
into the back of the mounting strap (A) - see Drawing 1.
• Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the backplate (E).
2. Attach mounting strap (A) to junction box (J) using two 1” screws (C).
1. To mount fixture, slip the two mounting screws (B) through the two mounting holes
(D) in the backplate (E) - see Drawing 1.
2. While holding fixture in place, thread the two ball knobs (F) on to the end of the
mounting screws (B), and tighten.
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com