Hinkley Lighting THISTLEDOWN 1281VZ User Manual

Start here, Assembly instructions

Advertising
background image

assembly instructions

Family: Thistledown Item No. 1281 VZ

1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.

*** The construction of this fixture will be accomplished by first installing the
glass, making all necessary electrical connections, and then mounting the
fixture to the pole.

start here

1281

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Note: Maximum wattage for 1281 fixture is 100 watts per bulb.

Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.

Drawing 1 - Fixture Mounting

Drawing 2 - Glass Replacement

1

2

4

5

6

7

3

1. To install or replace glass, remove knob (1) from top of roof (2) - see Drawing 1.
2. Remove decorative knob (3) from the top of the 3 uprights (6).
3. Remove roof (2) by sliding it off center stem (5).
4. Slip glass (4) into the fixture cage assembly (7), small hole in glass upwards.
Note: fixture should be lamped prior to installing or replacing the glass.
5. Replace roof (2) and line up top holes in upright (6) with hole in roof.
6. Thread decorative knob (3) back into roof (2).
7. Thread top knob (1) onto the exposed end of center stem (5) to secure roof.

1. After wiring connections are complete, slip post fitter (A) over top of pre-installed
post (B) making sure all wire connections are tucked inside the pole - see Drawing 1.
2. When fixture is slipped over pole make sure no wires are being pinched between the
top edge of the pole and the inside of the post fitter.
3. Thread the 3 set screws (C) into pre-tapped holes in post fitter.
4. Tighten screw (C) to secure fixture to post.

2.7.08

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

Advertising