Hinkley Lighting VALLEY 4701VK - Manual

assembly instructions
Family: Valley Item No. 4701 VK/BN
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the main body
of the fixture, making all necessary electrical connections and then mounting the fixture to
the ceiling.
star t here
47
01





1. To assemble main body, thread hex nut (3) on one end of threaded tubing (6) approximately 1/4”
- see Drawing 1.
2. Slip flat washer (4) onto other end of threaded tubing (6) and up against hex nut (3).
3. Slip plastic washer (5) onto threaded tubing (6) and up against flat washer (4).
4. Slip threaded tube (6) through center hole in glass (7).
5. Thread knurled nut (8) onto end of threaded tubing (6), and tighten against glass (7).
6. Slip spider assembly (9) onto threaded tubing (6).
7. Thread finial (10) onto end of threaded tubing (6) and tighten to secure spider assembly (9) to
glass (7).
8. Line up the holes in the arms of spider assembly (9) with holes in the arms of main body
assembly (1).
9. Thread screws (2) into holes to attach glass (7) to fixture.
10. Fixture can now be lamped accordingly.
Drawing 3 - Fixture Mounting
Drawing 2 - Strap Detail
B
(side view)
gull wing
bracket
B
1
Drawing 1 - Fixture Assembly
10
8
6
4
3
2
9
7
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction sheet (I.S.
18) and follow all instructions to make all necessary wiring connections. Then refer back to this
sheet to continue installation of this fixture.
1. Prepare gem strap (A) for mounting by threading two screws (B) provided into back of gull
wing bracket of gem strap (A) - see Drawing 2.
• Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the canopy (E) - see Drawings 2 and 3.
2. Mount gem strap (A) to junction box (J), using the two 1” screws (C).
1. To mount fixture, slide canopy (E) over screws (B) and secure with ball knobs (F) - see Drawing
3.
5
5
2.7.08
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com