Hinkley Lighting SAN CLEMENTE 2442 - Manual

assembly instructions
Family: San Clemente Item No. 2442 MB/OI/CB
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the
fixture, installing the mounting bracket to the junction box, making all neces-
sary electrical connections, and hanging the fixture from the ceiling.
start here
2442
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. To assemble fixture, slip center stem (4) along wire and thread into coupler (2),
located at top of cage assembly (1), approximately 3/8”.
2. Thread hex nut (3) down center stem (4) and tighten against coupler (2).
3. Slip cap (5) along wire and onto center stem (4).
4. Slip decorative knob with loop (4) along wire and onto center stem (4)
.
5. Please refer to the hanging instruction sheet (I.S. 19) provided to hang this fixture.
Then fixture can be lamped accordingly.
Drawing 1 - Fixture Assembly
6
5
4
3
2
1
2.7.08