Hinkley Lighting VIRGINIAN 5129PB - Manual

#5129 ASSEMBLY I.S. 99
Place lockwasher (3) over end of tube (1) having the upset (2). Place end of tube, with upset, through
large hole of bottom body (4) (bottom body has eight of the largest arms attached to it) and out the small
bottom hole. Screw loop (5) on to end of tube. Be sure loop is tight!
Lower column (7) over tube (1) with wider/open end of column pointing toward bottom body (4).
Before resting column on bottom body, push wire connectors (6) together until you hear them click. Rest
column on bottom body; make sure bottom of column checks inside the large hole of the bottom body and
the top of the tube goes through the center hole in the top of the column.
19
18
17
16
15
Place lockwasher (8) over top end of tube (1). Screw tube
(9), with hex-coupler (10) on top end of tube (1). USE PLIERS TO
TIGHTEN THIS TUBE!
Find the coiled piece of power supply wire (11), provided
with this fixture. One end has a wire connector and one end
doesn’t. Uncoil the wire and push the end without a wire
connector through the hole in the hex-hickey (10) and UP through
the tube (9). When the end of the cord comes up out of the top of
the tube, pull that end until there are about three inches of cord
left coming out of the hex-hickey hole.
12
21
14
9
11 13
10
Lower small body (12) over tube (9) so that the large hole is
facing down toward the column. Before resting the body on the
column, make two wire connections. First, make the connection
(13) between the wire connector coming from the top of the
column (7) and either one of the wire connectors coming out of
the small body. Push the connectors together until you hear them
click. Second, make the connection (14) between the power supply
wire and the second wire connector coming out of the small body.
Push the connectors together until you hear them click. Now you
can rest the small body on the column. Make sure that the top of
the column fits inside the large hole of the small body.
Thread the power supply wire through the open end of
column (15) (large hole) and out the small hole at the closed end.
Lower the column over the tube (9) and the small body (12). Make
sure that the open end of the column is facing the small body and
the end of the tube (9) goes through the small hole at the top of
the column.
8
7
6
1
2
3
4
5 20
Place one lockwasher (16)
over the top of the tube (9). Place the groundwire ring
(17) over the lockwasher (16). Place one lockwasher (18) over
the top of the groundwire ring (17).
Screw loop (19) on to top of tube (9). TIGHTEN LOOP!
Turn large arms (20) 90 degrees so that the light sockets
point up.
Turn small arms (21) 90 degrees so that the light sockets
point up.