Hinkley Lighting WHITNEY 4611BN - Manual

H I N K L E Y L I G H T I N G 12600 Berea Road Cleveland, OH 44111 800.446.5539 / 216.671.3300 www.hinkleylighting.com
assembly instructions
Family: Whitney Item No. 4611
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first determining
whether this fixture is to be chain hung or ceiling mounted, making all neces-
sary electrical connections, and then installing the glass.
start here
4611
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 1 - Fixture Assembly
Drawing 3 - Mounting instructions
J
D
C
F
E
G
Drawing 2 - Shade mounting
A
5
6
8
9
B
fixture
center column
7
2
5
6
1
4
3
1. Basic fixture assembly is accomplished by first, sliding center tube (2) along supply wire and
threading it into coupler (1) located on the top of the main body assembly (A), thread center
tube in approximately 3/8”.
2. Tighten hex nut (3) against coupler (1) to secure center tube.
3. Slip outer column tube (4) over center tube (2), making sure bottom of tube rest in recess in
main body assembly.
4. Slip flat plate (5) onto center tube (2).
5. Thread top coupler (6) onto end of tube (2) and tighten to secure center column assembly.
6. Slip center stem with loop (7) along wire and thread into coupler (6) and tighten.
6. Fixture body is ready for installaion.
Chain Hung
Shade Mounting - see Drawing 2
1. To attach shade, slip mounting ring (8) around top of center column coupler (6) and on
top of plate (5) - see Drawings 1 & 2.
2. Align holes (A) in mounting ring (8 ) with holes (B) in plate (5).
3. Thread in ball knobs with studs (9) to secure shade to fixture.
1. To prepare for mounting, thread screws (C) into the mounting bracket (D) - see
Drawing 3.
• Screws should be threaded into matching holes of the mounting strap,
making sure the screws line up with the holes in the fixture canopy (E).
2. Install mounting bracket (D) to junction box (J) using screws (F).
5. Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections. Then
refer back to the next step to mount the fixture.
6. To mount fixture, slip canopy (E) over screws (F) and thread on ball knobs (G) to
secure fixture.
3. Determine the length of chain you will require and hook one end to the fixture. Weave supply
wire through chain.
4. Attach chain to caonpy loop (L) and slip supply wire through center hole of loop.
Semi Flush Mounting
To mount fixture as a semi flush follow above directs for chain mounting, but on use one link of chain
to connect the fixture loop to the canopy loop (L).
L