Hinkley Lighting VALLEY FORGE 2071 - Manual

assembly instructions
Item No. 2071
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling
main body of the fixture, making all necessary electrical connections, and then
mounting the fixture to pre-installed post.
start here
2071
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
Drawing 2 - Fixture Mounting
Drawing 3 - Fixture Assembly
1. After wiring connections are complete, slip post fitter (A) over top of pre-installed
post (B) making sure all wire connections are tucked inside the pole - see Drawing 3 .
2. When fixture is slipped over pole make sure no wires are being pinched between
the top edge of the pole and the inside of the post fitter.
3. Thread the 3 screws (C) into pre-tapped holes in post fitter.
4. Tighten screws (C) to secure fixture to post, fixture can now be lamped accordin.
5
01.01.13
Drawing 1 - Glass Installation
1. Install glass panels (2) into cage assembly (1). It is necessary to remove cage (1) by
unthreading knob (7) from top of fixture - see Drawing 3 .
3. Position glass panel (2) between glass clips (3) located at the top and bottom of the
cage assembly (1).
4. Bent glass clips (3) over edge of glass panel to secure glass in position. Repeat for
remaining panels.
5. Lower base of fixture (A) can now be installed -see Drawing 2.
1. Slip cage assembly (1) over center stem (4) and slip holes (H) in bottom of cage
assembly (1) over locator pin (P) located on end of support arms (D). It will be necessary
2 . Thread top knob (7) onto end of center stem (4) to secure cage assembly (1) to
fixture base (A).
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
P
D
H
1 2
3
5
1
6
7
to adjust hex nut (5) with washer (6) on top, to proper height, so cage assembly (1) will
fit properly, but the top of the cage assembly is supported.
2. To install glass panels (2) slip them in through the bottom of the cage.