Hinkley Lighting VALLEY 4707VK - Manual

assembly instructions
Family: Valley Item No. 4707 VK/BN
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first determining the length of
stem required, mounting the mounting strap to the junction box, making all necessary
electrical connections, hanging the fixture from the ceiling, and then installing the glass.
star t here
47
07


SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. Determine the overall length you will need the assembled fixture to be.
2. Determine what stems will be needed to achieve the overall length you require.
(Additional stems are available and can be ordered. Ask your local Hinkley Lighting representa-
tive or visit www.hinkleylighting.com for information.)
3. Install stems by slipping them onto the supply wire of the fixture, threaded end up, and
threading them together.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction sheet (I.S.
18) and follow all instructions to make all necessary wiring connections. Then refer back to this
sheet to continue installation of this fixture.
1. Prepare gem strap (A) for mounting by threading two screws (B) provided into back of gull
wing bracket of gem strap (A) - see Drawing 1.
• Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the canopy (E) - see Drawings 1 and 2.
2. Mount gem strap (A) to junction box (J), using the two 1” screws (C) provided.
1. Hang the fixture by slipping the holes (D) in the canopy, over the screws (B) in the mounting
strap - see Drawing 2.
2. Thread on ball knobs (F) to secure fixture to the ceiling.
1. To install glass, remove socket ring (3) from socket (1) - see Drawing 3.
2. Slip glass (2) over socket (1).
3. Slip spacer (3) and then thread socket ring (4) back on to socket (1) to secure.
4. Use socket ring tool to tighten socket ring (4). Notches in socket ring fit into notches on socket
ring tool. Tighten socket ring until snug. Do not over tighten.
Drawing 2 - Fixture Mounting
Drawing 1 - Strap Detail
B
(side view)
gull wing
bracket
B
Drawing 3 - Glass Installation
6
3
4
2
1
notches
socket ring tool
2.7.08
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com