Hinkley Lighting SLOAN 4547RB - Manual

assembly instructions
Family: Sloan Item No. 4547
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first determining
the length of stem required, attaching the mounting strap to the junction box,
making all necessary elctrical connections, hanging the fixture from the ceiling,
and then installing the glass.
start here
45
47
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. Determine the overall length you will need the assembled fixture to be.
2. Determine what stems will be needed to achieve the overall length you require.
(Additional stems are available and can be ordered. Ask your local Hinkley Lighting
representative or visit www.hinkleylighting.com for information.)
3. Install stems by slipping them onto the supply wire of the fixture, threaded end up,
and threading them together.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
1. To install shade, remove socket ring (3) from socket (1) - see Drawing 3.
2. Slip shade (2) over socket (1) and thread socket ring (3) back on to socket (1) to secure.
3. Fixture can now be lamped accordingly.
Drawing 3 - Glass Installation
6
1
2
3
Drawing 2 - Fixture Mounting
Drawing 1 - Strap Detail
J
B
G
D
C
E
A
1. Install screws (A) into mounting plate (B) - see Drawing 1.
• Be sure the holes into which the screws are threaded match the spacing of holes (C)
in the canopy (D) - see Drawings 1 and 2.
2. Attach mounting plate (B) to junction box (J), using screws (G) provided and then
slip supply wires through large center hole.
1. Hang the fixture by slipping canopy (D) over screws (B) in the mounting strap - see
Drawing 2.
2. Thread on ball knobs (E) onto the end of screws (B) and tighten to secure fixture to
ceiling.
01.01.11
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com