Hinkley Lighting CONGRESS 3148 - Manual

assembly instructions
Item No. 3148
Drawing 2 - Fixture Mounting
Drawing 1 - Strap Detail
Drawing 3 - Glass Installation
J
B
G
A
3
2
1
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
D
C
E
1. Find a clear area in which you can work.
2.
3. Carefully review instructions prior to assembly.
from the ceiling, and then installing the glass.
star t here
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
01.01.13
1. Install screws (A) into mounting plate (B) - see Drawing 1.
Be sure the holes into which the screws are threaded mathc the spacing of the holes
(C) in the canopy (D) - see Drawing 1 and 2.
2. Attach mounting plate (B) to junction box (J), using screws (G) provided and then
slip supply wires through large center hole.
Make electrical connections from supply wire to the fixture lead wires. Refer to
instruction sheet (IS18) and follow all instructions to make all necessary wiring
connnections. Then refer back to this sheet to continue installation of this fixture.
1. Hang the fixture by slipping screws (A) through holes (C) of canopy
(D) - see Drawing 2.
2. Thread on ball knobs (E) onto end of screws (B) and tighten to secure fixture
to ceiling.
1. To install glass unthread knurled (2) in bracket (1) until glass can be slipped into
place - see Drawing 3.
2. Lamp fixture accordingly at this point.
3. Slip glass (3) into bracket (1) and hand tighten knurled knob (2) to secure glass.