Hinkley Lighting BRANTLEY 4633BN - Manual

assembly instructions
Family: Brantley Item No. 4633
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the main
body of the fixture, making all necessary electrical connections, hanging the fixture
from the ceiling and then installing the glass.
start here
4633
Note: Maximum wattage for 4633 fixture is 100 watts per bulb.
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. To assemble main body, spread arms (A) located on the main body assembly (1), until
they are equally spaced 120 degrees apart - see Drawings 1 & 2.
2. Please refer to the hanging instruction sheet (I.S. 19) provided to hang fixture. Then
refer back to this sheet to install glass.
1. To install glass, remove socket ring (3) from socket (B) - see Drawing 2.
2. Slip glass (2) over socket (B).
3. Thread socket ring (3) back onto socket (B) and tighten using socket ring tool
provided to secure glass (2). Note: Over tightening could cause damage to glass.
4. Repeat steps 1-4 for remaining glass.
5. Fixture can now be lamped accordingly.
Drawing 1 - Assembly
Drawing 2 - Glass Installation
A
3.6.09
A
A
A
120º
1
B
3
socket ring tool
2
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com