Hinkley Lighting GENTRY 3474OB - Manual

HINKLEY LIGHTING 33000 Pin Oak Parkway, Avon Lake, Ohio 44012 800.446.5539 ww w.hink leylighting.com
Item No. 3474
assembly instructions
3474
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembl
y.
*** The construction of this fixture will be accomplished by assembling main
body of fixture, mounting the mounting strap to the junction box, making all
necessary electrical connections and then mounting the fixture to the ceiling.
start here
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow instructions to make all necessary wiring connections.
5
07.21.05
Drawing 1 - Fixture Assembly
1. Slip loop (1) along supply wire (B) and thread onto threaded tube (A) located at the
top of the central body (2) - see Drawing 1.
2. Fixture is ready for installation.
1. Please refer to the hanging instruction sheet (I.S. 19)
Drawing 2 - Glass replacement
4
1
3
GLASS REPLACEMENT INSTRUTCTIONS:
1. It is recommended that the fixture be take down from the ceiling prior to replacing
the glass - see Drawing 2.
2. To replace glass first remove tear drop knobs (1) from bottom ring. Caution: if fixture
is installed when knobs are remove there is a possibility that all the glass could fall out.
3. Remove bottom ring (2), then remove rubber washers (3).
4. Slip glass (4) from between the uprights (5).
5. Replace glass (4) and re-assemble fixture by following step 1-3 in reverse order
2
5
1
2
A
B