Hinkley Lighting SOLARA 2021 - Manual

assembly instructions
Item No. 2021
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
.
start here
2021
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
Drawing 1 - Installing lamp
*** The construction of this fixture will be accomplished by first lamping the
fixture making all necessary electrical connections, and then mounting the
fixture to pre-installed post.
01.01.13
Drawing 2 - Fixture installation
1. After wiring connections are complete, slip post fitter (A) over top of pre-installed
post (B) making sure all wire connections are tucked inside the pole - see Drawing 3.
2. When fixture is slipped over pole make sure no wires are being pinched between
the top edge of the pole and the inside of the post fitter.
3. Thread the 3 set screws (C) into pre-tapped holes in post fitter.
4. Tighten set screws (C) with allen wrench provided to secure fixture to post.
A
B
C
C
ground wires
1. To lamp fixture prior to installation, remove the four screws (2) from the bottom
of the fixture body (1). Set aside in a safe place for use later - see Drawing 1.
2. Lift bottom plate (3) up.
3. Lamp fixture accordingly.
4. Replace plate (3) lining up screw holes (S) with tapped holes (T) in fixture body (1)
and thread screws (2) removed earlier.
5. Fixture is ready for installation.
S
T
1
2
3
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com