Hinkley Lighting CAMERON FR42344PCM - Manual

FR42344PCM
FREDRICK RAMOND
[DRAWING 1]
6.1.12
800.421.3517 WWW.FREDRICKRAMOND.COM
ASSEMBLY INSTRUCTIONS
Assembly of this fixture will be accomplished by first assembling the primary fixture
body, making all necessary electrical connections, hanging the fixture from the ceiling,
and then installing the shades.
SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
STEP 1
1 To complete primary assembly of the fixture body, slip center tube (1) along
wire and thread into top of fixture body (2) approximately 3/8" - See Drawing 1.
2
3
4 Next attach top of chrome accent strap (5) to wood center column (3) using
decorative knob and stud (6). Attach bottom end of strap to wood arm (7) using
decorative knob and stud (6).
5
Fixture is ready for installation.
STEP 2 Refer to Hanging Instruction Sheet [FRIS19-91] to hang fixture.Then refer back
to this sheet to install crystals.
STEP 3
Slip wood center column (3) over center tube (1).
Slip top coupler (4) along wire and thread onto end of center tube (1) and tighten
to secure wood center column (3). Sides of colums should be parallel to sides of
lower body.
6
5
4
3
7
1
2
6
stem
wire
wire
wire
stem
[DRAWING 2]
Determine the desired height the chandelier will be installed at.
The fixture is supplied with 1-6” stem and 2-12” stems. Determine what combina-
tion of stems needed to achieve desired length - see Drawing 2.
Slip stems over wire and thread first stem onto top of chandelier. Repeat this process
until all required stems are threaded together.
Slip wire through center of canopy swivel and thread onto stem assembly.
6
7
8
9
[DRAWING 3]
4
3
2
1
5
1 Slip candle sleeve (3) over socket (2) located on main body (1) - See Drawing 3.
2 Slip shade cup (4) of shade (5) onto top of candle sleeve (3).
3 fixture can be lamped accordingly at this time.