Hinkley Lighting CIRRUS 3806BN - Manual (Page 2)

1. Shut off electrical current before starting. If the fixture you are replacing is
turned on and off by a wall switch, simply turn the switch off. If not, remove
the appropriate fuse (or open the circut breakers) until the fixture is dead.
• DO NOT restore current - either by fuse, breaker or switch - until the new
fixture is completely wired and in place.
1. Fasten retainer plate (A) to outlet box with the original outlet box screws (B) - see
Drawing 1.
start here
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. Taking the chain, determine the length you require to hang the fixture.
2. Attach one end of the chain to the top loop of the fixture.
3. Attach other end of chain to loop (G) on canopy.
Drawing 1 - Fixture Assembly
1. Unwrap supply wire and ground wire and weave them up through the chain.
2. Slip supply wire and ground wire through center hole of loop (G).
Note: Get assistance for this step since fixture may be heavy and difficult to hold while attaching
the chain.
3. Connect ground wire to retainer plate (A) using green ground screw (H).
4. Make electrical connections from supply wire to fixture lead wires. Refer to instruc-
tion sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
5. Slip canopy (D) over nipple (F) and up against ceiling.
6. Thread decorative finial (C) onto end of nipple (F).
A
B
F
D
E
C
G
I.S.19-75-2
hanging instructions
I.S
. 19-75-2
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com