Hinkley Lighting MIDTOWN 4971BN - Manual

H I N K L E Y L I G H T I N G 12600 Berea Road Cleveland, OH 44111 800.446.5539 / 216.671.3300 www.hinkleylighting.com
assembly instructions
Family: Midtown Item No. 4971 BN
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. To assemble fixture, slip tubing (1) over wires and place into cap (2) on top of cage
assembly (3) - see Drawing 1.
2. Slip wires through center stem (4) that is attached to the canopy (D) and thread end
of stem (4) into coupler (5) located on top of cage assembly (3) and tighten.
*** The construction of this fixture will be accomplished by first assembling the
the main body of the fixture, making all necessary electrical connections,
hanging the fixture from the ceiling, and then installing the glass.
start here
4971
Note: Maximum wattage for 4971 fixture is 100 watts per bulb.
D
4.28.10
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. Prepare mounting strap (B) for mounting by installing screws (A) into mounting
plate (B) - see Drawing 2.
• Be sure the holes into which the screws are threaded match the spacing of holes (C)
in the canopy (D) - see Drawings 2 and 3.
2. Attach mounting plate (B) to junction box (J), using screws (F) provided and slip
supply wires through large center hole.
1. Hang the fixture by slipping canopy (D) over screws (A) and hold in position - see
Drawings 2 and 3.
2. Thread ball knobs (E) onto end of screws (A) and tighten to secure fixture to ceiling.
1. Fixture can now be lamped accordingly.
2. Thread center stem with hex nut (9) into coupler (10) at base of socket assembly
(11) approximately 3/8” and tighten hex nut to secure center stem - see Drawing 1.
3. Slip tubing (12) over center stem and hold in position.
4. Slip cap (13) over center stem followed by metal flat washer (14) and rubber washer
(15) and hold in position.
5. Slip glass (8) onto center stem and hold in position.
6. Slip flat washer (16) onto center stem and hold both glass and washer in position
while threading on hex nut (17). Tighten hex nut (17) to secure glass to fixture.
7. Slip cap (18) onto center stem and hold in position.
8. Thread on bottom knob (19) and tighten to complete assembly.
Drawing 3 - Fixture Mounting
1
4
2 3
5
11
Drawing 1 - Fixture Assembly
Drawing 2 - Strap Detail
D
E
C
J
B
A F
5
9
13
8
10
12
14
15
17
19
16
18