Hinkley Lighting MARCELLINA 4403GR - Manual

assembly instructions
Family: Marcellina Item No. 4403 GR
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first determining
whether it is to be ceiling mounted or chain hung, assembling the main body of
the fixture, making all necessary electrical connections, mounting the main body in
the style you selected, and then installing the crystals.
start here
4403
Note: Maximum wattage for 4403 fixture is 40 watts per bulb.
1. To assemble fixture, if hanging fixture - slip loop (1) along wire and thread onto
threaded tube (2) at top of fixture - see Drawing 2.
2. Rotate arms (3) until they are equally spaced 120 degrees apart - see Drawing 1.
3. Slip candle sleeve (4) over each socket (5) - see Drawing 2.
4. Slip glass bobesche (6) over each candle sleeve (4).
5. Slip glass cup (7) over each candle sleeve (4).
6. Fixture can now be lamped accordingly.
If hanging the fixture, please refer to hanging instruction sheet (I.S.19) provided and
refer back to section 5 to install fixture crystals.
If mounting fixture, slip canopy (D) over threaded tube (2) then thread hex nut (12)
onto threaded tube (2) and tighten to secure. Refer to next section (section 3) to
continuing mounting installation of this fixture.
Drawing 1 - Fixture Assembly
Drawing 2 - Fixture Assembly
12
D 1
2
9
8
11
7
6
5
13
13
4
1. To install crystals, thread small crystal ball (8) onto threaded tube (9) and thread small
crystal ball (10) onto threaded tube (11) - see Drawing 2.
2. Hang crystals (13) from areas indicated. 5
12.29.08
3
3
3
120º
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. Prepare mounting strap (B) for mounting by installing screws (A) into mounting
plate (B) - see Drawing 3.
• Be sure the holes into which the screws are threaded match the spacing of holes (C)
in the canopy (D) - see Drawings 3 and 4.
2. Attach mounting plate (B) to junction box (J), using screws (F) provided and slip
supply wires through large center hole.
1. Hang the fixture by slipping canopy (D) over screws (A) and hold in position - see
Drawings 3 and 4.
2. Thread ball knobs (E) onto end of screws (A) and tighten to secure fixture to ceiling.
Drawing 4 - Fixture Mounting
Drawing 3 - Strap Detail
D
E
C
J
B
A F
10
3
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com