Hinkley Lighting BARCELONA FR44104SLF - Manual

FR44104
BARCELONA
ASSEMBLY INSTRUCTIONS
Assembly of this fixture will be accomplished by first assembling the main fixture
body, installing mounting hardware to junction box, mounting main body to ceiling
and then installing the crystal body assembly.
SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
STEP 1
1 Prepare mounting strap (a) by threading the two 1 1/2” long mounting screws (b)
into the back of the mounting strap (a), making sure the holes into which the
screws are threaded match the spacing of holes (d) in the backplate (e) - See
Drawing 2.
2 Attach mounting strap (a) to junction box (j) using two screws (c).
3 Make electrical connections from supply wire to fixture lead wires. Refer to
instruction sheet [FRIS18] and follow all instructions to make all necessary
wiring connections. Then refer back to this sheet to continue installation of
this fixture.
4 To mount fixture, slip the two mounting screws (b) through the two mounting
holes (d) in the backplate (e).
5 While holding fixture in place, thread the two ball knobs (f) on to the end of the
mounting screws (b), and tighten.
STEP 2
1 Fixture can now be lamped accordingly.
2 To install glass, thread hex nut (2) onto center stem (3) approximately 3/8” - See
Drawing 1.
3 Thread center stem (3) with hex nut into coupler (4) approximately 3/8”.
4 Tighten hex nut (2) up against coupler (4) to secure center stem (3).
5 Thread hex nut (5) followed by rubber washer (6) onto center stem (3).
6 Slip glass (7) onto center stem (3) and hold in position.
7 Thread ball coupler (8) onto center stem (3) approximately 1/4”.
8 Slip leaf (9) onto center stem (3) and hold in position.
9 Slip spider assembly (10) onto center stem (3) and hold in position.
10 Slip leaf (11) onto center stem (3) and hold in position.
11 Thread bottom ball knob (12) onto center stem and tighten to secure glass
and spider assembly.
STEP 3 Refer to Crystal Installation Sheet provided to install crystals.
[DRAWING 1]
[DRAWING 2]
1
j
a
c
e
d
f
b
4
2
3
5
6
8
7
11
12
9
Bulbs: 60W MED.
10
09.12.08