Hinkley Lighting SHELTER 1322 - Manual

assembly instructions
Family:Shelter Item No. 1322
*** The construction of this fixture will be accomplished by first assembling the main
body, determining the length of stem required, installing the mounting hardware,
making all neccessary electricla connections, and then hanging the fixture.
start here
1322
Note: Maximum wattage for 1322 fixture is 100 watts per bulb.
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. Determine the overall length you will need the assembled fixture to be.
2. Determine what stems will be needed to achieve the overall length you require.
(Additional stems are available and can be ordered. Ask your local Hinkley Lighting
representative or visit www.hinkleylighting.com for information.)
3. Install stems by slipping them onto the supply wire of the fixture, threaded end up,
and threading them together.
1. One upright (1) is removable to facilitate installation or replacement of the glass
and lamping of the fixture - see Drawing 3.
2. Remove screws (3) from top of fixture and pull upright (1) off fixture.
3. Fixture can now be lamped accordingly.
4. Tilt glass (2) and slip up into top of fixture, lift glass (2) over center hub (4) and set
on uprights (1).
5. Slide upright (1) back onto the fixture, over the brackets (5), lining up holes in
upright (1) with holes in brackets (5).
6. Thread top screw (3) into top of bracket (5).
7. Lift glass (2) up and using a short screw driver, thread screw (3) into bracket (5) to
secure lower portion of upright.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
Drawing 3 - Glass Installation
1
2
4
3 5
3
Drawing 2 - Fixture Mounting
Drawing 1 - Strap Detail
J
B
G
D
C
E
A
1. Install screws (A) into mounting plate (B) - see Drawing 1.
• Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the canopy (E) - see Drawings 1 and 2.
2. Attach mounting plate (B) to junction box (J), using screws (G) provided and then
slip supply wires through large center hole.
1. Hang the fixture by slipping canopy (D) over screws (B) in the mounting strap - see
Drawing 2.
2. Thread on ball knobs (E) onto the end of screws (B) and tighten to secure fixture to
ceiling.
11.15.09
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com