Hinkley Lighting BRIGHTON 2291 - Manual

assembly instructions
Family: Mission Item No. 2291
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling
main body of the fixture, installing the fixture glass, making all necessary
electrical connections and then mounting the fixture to pre-installed post.
start here
2291
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
Drawing 2 - Glass Installation
Drawing 3 - Fixture Mounting
Drawing 1 - Fixture Assembly
1. Fixture is mounted using 3 - 1/4-20 set screws.
2. Make all necessary electrical connections following wiring instructions below.
5 1. After wiring connections are complete, slip post fitter (A) over top of pre-installed
post (B) making sure all wire connections are tucked inside the pole - see Drawing 3.
2. When fixture is slipped over pole make sure no wires are being pinched between
the top edge of the pole and the inside of the post fitter.
3. Thread the 3 set screws (C) into pre-tapped holes in post fitter.
4. Tighten screws (C) to secure fixture to post.
9.12.08
6
7
4
5
1. To install glass, unscrew top knob (1) from nipple (5) - see Drawing 1.
4. Slip glass panel (4) through top of cage assembly (5) - see Drawing 2.
5. Slip bottom of glass panel (4) into the bottom of the cage assembly (5).
6. Slip top of glass panel (4) up against cage assembly (5) .
7. Bend upper glass clips (6) down to position glass panels (4).
8. Bend lower glass clips (7) up to secure glass panels (4).
9. Repeat steps 2-6 for remaining panels.
10. Fixture can now be lamped accordingly.
11.
1
2
3
4
5
2. Remove cap (2) and unthread all hex nuts, and remove lockwashers (3).
3. Slip roof (4) off of center stem (5), glass can now be installed.
Replace roof by following steps 1-3 in section 2 in reverse order.
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com