Hinkley Lighting CASA 1141OL - Manual

assembly instructions
Family: Casa Item No. 1141 OL
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first making all necessary
electrical connections, mounting the fixture to pre-installed post and then lamping
fixture.
start here
1141
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Note: Maximum wattage for 1141 fixture is 60 watts per bulb.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
Drawing 1 - Fixture Mounting
Drawing 2 - Lamping Fixture
1. Fixture is mounted using 3 - 1/4-20 set screws.
2. Make all necessary electrical connections following wiring instructions below.
1. After wiring connections are complete, slip post fitter (A) over top of pre-installed
post (B) making sure all wire connections are tucked inside the pole - see Drawing 1.
2. When fixture is slipped over pole make sure no wires are being pinched between the
top edge of the pole and the inside of the post fitter.
3. Thread the 3 set screws (C) into pre-tapped holes in post fitter.
4. Tighten screw (C) to secure fixture to post.
11.24.08
1
3
5
9
8
2
4
3. To assemble fixture, slip candle sleeve (1) over socket (2) - see Drawing 2.
4. Thread center stem (3) into top of cluster (4).
5. Fixture can now be lamped accordingly.
6. Slip glass (5) onto fixture.
7. Slip roof (6) onto center stem (3) making sure pins (7), on the bottom of the roof
scrolls, are inserted into top of uprights (8).
7. Thread loop (9) onto the exposed end of center stem (3) and tighten.
5
7
6 B
A
C
First attach the roof (6) to the scroll work (C) by removing the hex nut (A) and the
flat washer (B) from the threaded tube on the scroll work. 1.
Slip roof onto threaded tube followed by flat washer (B), then thread on hex nut (A)
and tightedn to secure roof (6). 2.
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com