Hinkley Lighting WINGATE 3008OZ - Manual

assembly instructions
Family: Windgate Item No. 3008
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling
the fixture, installing the fixture glass, installing the mounting bracket to the
junction box, making all necessary electrical connections and hanging the
fixture from the ceiling.
start here
3008
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.



1. To assemble fixture, slip center tube (1) along wire and thread into top of fixture
body (2) - See Drawing 1.
2. Slip candle sleeve (3) over socket (4).
1. To install glass slip one rubber washer (6) onto studs (7). Now slip glass panel (5) onto
studs (7) and hold in position - See Drawing 2.
2. Slip second rubber washer (6) onto studs (7) and then thread decorative knob (8)
onto end of stud (7) to secure glass.
1. Note: glass can be installed before or after hanging. Refer to the hanging
instruction sheet (I.S. 19) provided to hang this fixture. Then fixture can be lamped
accordingly.
Drawing 1 - Fixture Assembly
Drawing 2 - Glass Installation
1
2
6.01.11
3
3
4
5
7
6 6
7 4
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com