Hinkley Lighting MASON 5693TB - Manual

assembly instructions
Family: Mason Item No. 5693
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first mounting the
mounting strap to the junction box, making all necessary electrical connections,
assembling the main body of the fixture, mounting the fixture to the wall,
and then installing the glass.
start here
5693
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 2 - Fixture Assembly
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
5
1. Remove main mounting plate (A) from fixture back plate (B) by removing the four
flat head screws (C) - see Drawing 1.
2. Slide the wires from the junction box, through the large center hole, making sure
curved slots (D) line up with the threaded holes (E) in the junction box.
3. Using two 8-32 screws (F) attach the main mounting plate (A) to the junction box,
making sure side of mounting plate (A) is square to ceiling.
1. Mount the fixture by sliding the back plate (B) over mounting plate (A) - see
Drawing 1.
2. Attach the back plate (B) to the mounting plate (A) using the screws (C).
6.1.11
1. To install glass remove socket ring (2) and spacer (3) from socket (1).
2. Slip hole in back of glass (4) over socket (1) followed by spacer (3).
3. Thread socket ring (2) onto socket (1) and tight to secure glass (4) making sure
glass is level.
4. Fixture can now be lamped accordingly. After lamping make sure to clip bulb shield
(7) onto the bottom of the socket (1) and then use one finger push the raised point of
the second metal clip (7-1), and then spread the onside of the clip outward so it would
fit over the bottom clip, then slide the clip on and over the bottom clip.
5. Decorative grill (5) tabs can be slip over crossbar (6) and centered. Fixture is
complete. Note: there are locator tabs on the back of crossbar (6) to help locate gril in
the center of the crossbar.
Drawing 1 - Fixture Mounting
A
B
C
D
F
C
1
2
3
4
5
6
7
7-1
buld shield detail drawing
bottom shield
top shield
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com