Hinkley Lighting CELESTE FR42645SLF - Manual

FR42645SLF
CELESTE
ASSEMBLY INSTRUCTIONS
Assembly of this fixture will be accomplished by first assembling the main body,
connections, hanging the fixture and then attaching the fixture glass.
SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
STEP 1
STEP 2 Refer to Hanging Instruction Sheet [FRIS19] to hang fixture. Then refer back
to this sheet to continue installation of this fixture.
STEP 3
1 To install glass (7), slip glass over socket (e).
2 Slip candle sleeve (8), ringed end down over socket (e) making sure end of candle
sleeve passes throught hole in glass so flat ring holds glass in position.
[DRAWING 1]
Bulbs: 60w canD. Replacement Parts: GLASS: R42640gl CRYSTAL: R42640CRY
7.1.08
800.421.3517 WWW.FREDRICKRAMOND.COM
installing the mounting hardware to the junction box, making all necessary electrical
d
b
2
5
4
6
7
8
9
1
a
3
c
1 Spread out arms (a) on lower body (1) until they are approximately 72 degree
apart - See Drawing 1.
2 Slip secondary arm assembly (2) along wire and onto main body (1), and
spread arms (b) apart until they are equally spaced over lower arms (a).
3 Slip center column (3) along wire and thread onto coupler (c) on top of main
body (1).
4 Attach top of arms (b) to center column (3) using ball knob studs (4).
5 Slip loop (5) along wire and thread onto top of center column (3).
6 Thread decorative finial (6) onto bottom of fixture.
7 Crystals (9) can now be threaded onto the end of the stems (d).
8 Fixture can now be installed.
e