Black & Decker LST1018 - Manual (Page 13)

REWINDING SPOOL FROM BULK LINE (USE ONLY .065 IN.
DIAMETER LINE)
Bulk line is also available for purchase from your local retailer.
NOTE: Hand wound spools from bulk line are likely to become
tangled more frequently than Black & Decker factory wound spools.
To install bulk line, follow the steps below.
• Turn off the trimmer and remove the battery.
• Press the release tabs on the line spool cover, as shown in figure Q
and remove the cover by pulling it straight off.
• Remove the spool from the tool and remove and discard all line on the
spool.
• Insert one end of the bulk line into
the hole in the spool shown in
figure T about 1/2 in. (12mm).
• Hold the line in the hole and pull
the rest of the line through the slot
in the spool, shown in figure T.
• Snugly and evenly wind the bulk line
onto the spool in the direction of the
arrow on spool in figure T until it is
nearly full.
• Insert the line end through the eyelet
in the spool hub, as shown in
figure R. Pull the line through the
hole to maintain tension while
placing the spool down into the hub
with the notched side exposed, as shown in figure S.
• Press the spool down GENTLY and rotate it until you feel it drop into
place.(Wheninplace,thespoolwillturnafewdegreesleftandrightfreely.)
• Snap the spool cover back on, insert the battery and turn the tool on.
In a few seconds or less youʼll hear the nylon line being cut
automatically to the proper length.
Maintenance
• Use only mild soap and damp cloth to clean the tool. Never let any
liquid get inside the tool; never immerse any part of the tool into a
liquid.
•
WARNING
:
Remove or disconnect battery before
servicing, cleaning or removing material from the gardening appliance.
Accessories
• Recommended accessories for use with your tool are available from
your local dealer or authorized service center. If you need assistance
regarding accessories, please call: 1-800-544-6986.
• Use Black & Decker replacement spool No. AF-100.
• Spool cap replacement part no. RC-100-P.
• Reload nylon line (either bulk or prewrapped replacement spool) as
shown in this manual.
• USE ONLY .065 in. (1.65mm) DIAMETER NYLON MONOFILAMENT
LINE. Heavier line will overload the motor, cause overheating and will
impair the automatic feed. This line is available at your local dealer or
authorized service center.
• Do not use fishing line or other lines that are not recommended.
•
WARNING
:
The use of any accessory not
recommended for use with this tool could be hazardous.
IMPORTANT
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment should be performed by authorized service centers
or other qualified service organizations, always using identical
replacement parts.
13
T