Hinkley Lighting FREEPORT 1800 User Manual

Start here, Assembly instructions

Advertising
background image

Family: Freeport Item No. 1800

H

assembly instructions

1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

*** The construction of this fixture will be accomplished by mounting the mounting
strap to the junction box, making all necessary electrical connections, and then
mounting the fixture to the wall.

start here

Drawing 3 - Fixture Assembly

1800

1. Prepare gem strap (A) for mounting, by threading the two screws (B) provided into
the back of the gull wing bracket on gem strap (A) - see Drawing 1.
Be sure that holes into which the screws are threaded match the spacing of the
mounting holes (D) in the back plate (E) - see Drawings 1 and 2.
3. Mount gem strap (A) to junction box (J) using two 1” screws (C) provided.

Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet 18 (I.S. 18) and follow instructions to make all necessary wiring connections.
Then refer back to this sheet to complete installation of this fixture.

1. Mount the fixture by slipping the holes (D) in the backplate (E) over the screws (B)
in the mounting strap (A) - see Drawing 2.
2. Hold fixture against wall and thread ball knobs (F) onto end of screw (B) showing
through the backplate (E).

Drawing 1 - Strap Detail

Drawing 2 - Fixture Mounting

B

(side view)

gull wing

bracket

backplate

B

1. Remove screws (2) from under roof (1). Make sure cage assembly (3) is supported
while removing screws. When last screw is removed the cage assembly can drop off
the fixture - see Drawing 1.
2. Remove screws (4) that hold the glass clips (5) in place.
3. Glass (6) can now be lifted out of the cage assembly (3).
4. To replace glass, follow steps 1-3 in reverse order.

5

1

3

4

5

2

6

11.12.09

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

Advertising