Hinkley Lighting PLANTATION 2124PZ - Manual

assembly instructions
Family: Plantation Item No. 2124 CB
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling
the main body of the fixture, mounting the mounting strap to the junction
box, making all necessary electrical connections, mounting the fixture to the
wall, and then installing the glass.
start here
2124
1. Mount the fixture to the wall by slipping holes (E) in backplate (C), over screws (F) in
retainer plate (G) and securing with ball knobs (A) - see Drawing 1.
1. Prior to installing glass, fixture can now be lamped accordingly.
2. To install glass, thread center stem (3) into top of harp (5) and tighten - see Drawing 2.
3. Slip glass (1) over center stem (3) and harp (5) and onto fixture base (2).
4. Place crown (4) on top of glass (1), making sure to line up cap (7) with attachment
point (6).
5. Thread knurled cap (7) to backplate (C) at attachment point (6).
6. Tighten secondary knurled cap (9) against knurled cap (7) to secure arm (8) in place.
7. Thread top finial (10) onto center stem (3).
Drawing 1 - Fixture Mounting
1. To assemble main body, remove ball knobs (A) from backplate (C) and remove
retainer plate (G) - see Drawing 2.
2. Slip wire from junction box (B) through the 9/16” dia. access hole in the retainer plate (G).
3. Remove appropriate knock outs from the star pattern on the retainer plate (G) that
match the mounting hole location on your junction box (B).
4. Mount retainer plate (G) to the junction box (B) using the screws provided.
5. The top and bottom ends of the retainer plate have additional attachments points
that can be used. To attach the plate at these points use the wood screws (D) provided.
3
5
Drawing 2 - Glass Installation
A
C
E
A
10
4
3
5
2
6
8 7
9
1
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
B
D
D
F
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
C
2.7.08
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com