Hinkley Lighting FLUSH MOUNT 5421 User Manual

Start here, Assembly instructions

Advertising
background image

assembly instructions

Family: Ocho Item No. 5421 CM

1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.

1. Prepare mounting disc (A) by threading two screws (B) provided into the back of the
mounting strap (A) - see Drawing 1.
Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the canopy (E).
2. Attach mounting disc (A) to junction box (J) using two 1” screws (C) provided.

1. Hang the fixture by slipping the holes (D) in the ceiling pan (1) over the screws (B) in
the mounting disc (A) - see Drawing 1.
2. Thread on ball knobs (F) to secure fixture to ceiling.

1. To install glass, thread center stem (2) into coupler (A) located in the center of the
ceiling pan (1) - see Drawing 2.
2. Using a 9/16” wrench, tighten hex nut (3) up against coupler (A) to lock center
stem (2) in place.
3. Fixture can now be lamped accordingly.
4. Slip glass (4) onto center stem (2) and hold in position.
5. Slip rubber washer (5) onto center stem (2) and hold in position.
6. Slip metal washer (6) onto center stem (2) and hold in position.
7. Thread hex nut (7) onto center stem (2) and tighten.
Note: Over tightening could cause damage to glass.
8. Thread bottom cap (8) onto end of center stem (2) and tighten.

*** The construction of this fixture will be accomplished by first mounting the
mounting strap to the junction box, making all necessary electrical connections,
hanging the fixture from the ceiling, and then installing the fixture glass.

start here

5421

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.

5

Drawing 1 - Fixture Mounting

Drawing 2 - Glass Installation

J

D

F

1

B

A

C

1

2

4

3

5

6
7

8

A

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

Advertising