Hinkley Lighting ATLANTIS 1643 - Manual

assembly instructions
Family: Atlantis Item No. 1642 / 1643
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. Prepare mounting strap (A) by threading the two 8-32 x 1 mounting screws (B)
into the back of the mounting strap (A) - see Drawing 1.
• Be sure the holes into which the screws are threaded match the spacing of holes (E)
in the backplate (F).
2. Attach mounting strap (A) to junction box (J) by threading 2 screws (C) provided
into holes (D) of junction box (J).
3. Un-thread the 2 screws (3) from the top roof (4) and remove lens cover (4).
*** The construction of this fixture will be accomplished by first attaching the
mounting strap to the junction box, making all necessary electrical connections,
mounting the fixture to the wall, and then lamping the fixture.
start here
1643
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 1 - Fixture Mounting
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
06.01.13
1642
1. To mount fixture to wall, first remove top roof (4) by removing screws (3)
- see Drawing 1.
J
D B C
A 5
3
4
E
F
2. Line up holes (E) in backplate (F) and slide fixture over both 8-32 x 1 screws.
3. While holding fixture in place, thread the two 8-32 nuts (5) provided onto
screws (B) and tighten to secure fixture to wall.
4. Fixture can be lamped accordingly at this time.
5. Replace roof (4) and secure with screws (3) removed previously.