Hinkley Lighting DORIAN 2195 - Manual

H I N K L E Y L I G H T I N G 133000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440 653 5500 hinkleylighting.com
assembly instructions
Item No. 2195
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. Prepare mounting strap (A) by threading the two 8-32 mounting screws (B)
into the back of the mounting strap (A) - see Drawing 1.
• Be sure the holes into which the screws are threaded match the spacing of holes (E)
in the backplate (F).
2. Attach mounting strap (A) to junction box (J) by threading 2 screws (C) provided
into holes (D) of junction box (J).
1. To mount fixture, remove bottom lens (1) by removing the four corner screws (2).
Set parts aside after removal to be used later - see Drawing 2.
2. While holding fixture, line up holes (D) in backplate (E) and slide fixture over both
screws (B) - see Drawing 1.
3. While holding fixture in position, thread the two barrel knobs (F) onto end of screws
(B) and tighten to secure fixture.
1. Bottom of fixture can now be lamped accordingly.
2. Re-place bottom lens (1) and screws (2) - see Drawing 2
3. To lamp top of fixture remove phillip screws (3), and lift off top cap (4) off of fixture.
4. Fixture can now be lamped accordingly.
5. Replace top cap (4) and screws (3) to complete assembly.
*** The construction of this fixture will be accomplished by first attaching the
mounting strap to the junction box, making all necessary electrical connections,
mounting the fixture to the wall, and then lamping the fixture.
start here
2195
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 1 - Fixture Mounting
Drawing 2 - Fixture Assembly
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
5
J
1
B
C
A
E
F D
01.01.13
2
Drawing 3 - Fixture Assembly
3
4