Hinkley Lighting 6.5FT POST WITH CAST ALUMINUM BASE 6638 - Manual

Please do the following to insure safe and easy installation:
A. Read installation instructions and review diagrams thoroughly before beginning.
B. For proper installation, secure sevices of a qualified electrician.
DISCONNECT THE POWER (CAUTION)
Always shut off power at the circuit breaker or disconnect fuse when installing or
or repairing this item.
1. WIRE POWER TO FIXTURE LOCATION
A. Be sure to consult local codes before beginning electrical work.
B. Wire power through conduit that meets local codes from the power source to
the site of the fixture.
C. It is recommended that there is 100 inches of wire above grade at the end of the run
to allow for wiring of fixture.
2. PREPARE FOOTING
A. To ensure adequate support, the concrete footing used to mount the 6638 pole
should be 16” cubed, or according to local building codes. See installation instruction
sheet for more details.
B. This pole is supplied with a cast metal template for installing the anchor bolts in
there correct position. -See Drawing 2.
C. Thread anchor bolts into the corners of the cast metal triangle template. Making sure
the end of the bolt measure 2” (but not less than 1-3/4” ) from the bottom of the metal
template. -See Drawing 2.
D. Pour cement into prepared hole and before cement sets place prepared template
with anchor bolts into cement. Making sure cast metal template rests on top of cement.
3. POLE ASSEMBLY
1. Take mid section of pole (2) and line up holes (A) with holes (B) in the
bottom section (1) - See Drawing 1 for reference.
2. Thread allen head screws (C) in place, to secure sections (1) and (2).
3. Thread top section (3) into top of mid section (2) and tighten.
4. Thread set screw (S) into threaded hole located in area (H) and tighten to secure top
section of pole.
4. Slip post cap (4) over top of section (3). Making sure holes (D) and (E) are aligned.
5. Thread in flat head phillip screws(F) into hole (E) to secure post cap (4).
6. Pole is complete and may be mounted to footer.
F
D
E
DRAWING 2
DRAWING 1
A
C
B
Assembly and Installation instructions for 6638BK
S
H