Hinkley Lighting CHESTERFIELD 1381 - Manual

assembly instructions
Item No. 1381
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. Thread center stem (2) [bead end down], into threaded hole, located on the top of
the cluster assembly (3) of the main body assembly (1) - see Drawing 1
2. Slip candle sleeves (4) over socket (S).
1. To install glass, slip glass (5) over center stem (2) and cluster assembly (3) making
sure glass seats properly inside ring (R) - see Drawing 1.
2. Fixture can now be lamped accordingly.
3. Slip roof assembly (6) onto fixture by slipping center stem (2) through center hole
in roof assembly (6) making sure glass seats inside ring (T).
4. Thread knob (7) onto the end of center stem (2) that is protruding through the top
of roof assembly (6). Hand tighten only.
*** The construction of this fixture will be accomplished by first assembling
main body of the fixture, making all necessary electrical connections, mounting
the fixture to pre-installed post, and then installing the glass.
start here
1381
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
Drawing 2 - Fixture Mounting
Drawing 1 - Fixture Assembly
5
1. After wiring connections are complete, slip post fitter (A) over top of pre-installed
post (B) making sure all wire connections are tucked inside the pole - see Drawing 2.
2. When fixture is slipped over pole make sure no wires are being pinched between
the top edge of the pole and the inside of the post fitter.
3. Thread the 3 screws (C) into pre-tapped holes in post fitter.
4. Tighten to secure fixture to post.
01.01.13
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
T
S
R
1
2
3
4
5
6
7