Hinkley Lighting HAMPTON 3214AN - Manual

assembly instructions
Family: Hampton Item No. 3214
1. Find a clear area in which you can work.
1. Rotate the three uprights (A) until they are approximately 90 degrees apart - see
Drawing 1 .
2. To attach shades first remove socket ring (3) from socket (1) - see Drawing 2.
3. Slip shade harp (2) over socket and hold in position.
4. Thread socket ring (3) back onto socket to secure shade harp (2).
5. Fixture can be installed at this time please refer to mounting instructions (IS-19)
provided with this fixture. Then refer back to this sheet to finish installation.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the
main body structure, installing the mounting hardware to the junction box, hanging
the fixture from the ceiling, and then completing the fixture assembly.
start here
3214
10.26.10
3
Drawing 1 - Fixtu
Drawing 2 - Fixture Assembly
re Assembly
1
2
4
A
3
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
6
A
5
7
B
1. Attach acrylic lens (4) to harp by slipping center hole over threaded tube on harp
followed by cap (5) - see Drawing 2.
2. Hold both lens and cap in position and thread on knob (6) and tighten to secure
parts.
3. It is recommended that the fixture be lamped accordingly at this time.
4. Take shade (7) and manuver shade over acrylic lens so tabs (B) rest on the top side
of the lens. Center shade on lens and assembly is complete.
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com