Hinkley Lighting SEDGWICK 1771 - Manual

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 www.hinkleylighting.com
assembly instructions
Item No. 1771
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first installing the glass, making
all necessary electrical connections, and then mounting the
fixture to the pole.
star t here
1771
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction sheet (I.S.
18) and follow all instructions to make all necessary wiring connections. Then refer back to this
sheet to continue installation of this fixture.
Drawing 2 - Fixture Mounting
Drawing 1 - Glass Installation
1. After wiring connections are complete, slip post fitter (A) over top of pre-installed post (B)
making sure all wire connections are tucked inside the pole - see Drawing 1.
2. When fixture is slipped over pole make sure no wires are being pinched between the top edge of
the pole and the inside of the post fitter.
3. Thread the 3 set screws (C) into pre-tapped holes in post fitter.
4. Tighten screw (C) to secure fixture to post.
6.1.12
21
24
22
1. To install glass, open side door by lifting latch (L) , located on the left side of the fixture when
looking at it straight on - see Drawing 1.
2. Install panels of glass (1) in fixture by slipping the glass into the cage through the door opening
(2) at a slight angle and around the socket (3) and into position - see Drawing 1.
3. Fold glass clips (4) located at the top and bottom of the cage so they contact the glass and hold
it in position.
4. Repeat procedure for remaining panels of glass.
5. Fixture can now be lamped accordingly.
Note: If door glass is broken, the entire door can be replaced by removing hinge pin (P). Replace
door and re- insert hinge pin (P).
23