Hinkley Lighting VIRGINIAN 5127PB - Manual

#5127 ASSEMBLY I.S. 98
Place lockwasher (3) over end of tube (1) having the upset (2). Place end of tube, with upset, through
large hole of bottom body (4) (bottom body has eight of the largest arms attached to it) and out the small
bottom hole. Screw loop (5) on to end of tube. Be sure loop is tight!
Lower column (7) over tube (1) with wider/open end of column pointing toward bottom body (4).
Before resting column on bottom body, push wire connectors (6) together until you hear them click. Rest
column on bottom body; make sure bottom of column checks inside the large hole of the bottom body and
the top of the tube goes through the center hole in the top of the column.
Thread wire connector (8) through side hole, not center hole, in cap (9) and middle body (10)
(middle body has eight middle-sized arms attached to it). Stack the cap and body on top of column. Make
sure that top of tube (1) goes through center holes
of cap and middle body.
Place lockwasher (11) inside body (10) over
13 17
top end of tube (1).
Screw tube (13), with hex-coupler (12) on to
top end of tube (1). USE PLIERS TO TIGHTEN THIS
TUBE!
12 14 Make wire connection (14) between wire con-
nector (8) and either one of the two connectors
11
coming from the middle body. Push connectors to-
gether until you hear them click.
10 Turn large arms (15) 90 degrees so that the
light sockets point up.
9 16
Turn medium arms (16) 90 degrees so that the
light sockets point up.
8
Go to other side...
7
1
6
2
3
4
15
5