Hinkley Lighting NEST FR41612ORB User Manual
Nest
FR41612ORB
NEST
ASSEMBLY INSTRUCTIONS
Assembly of this fixture will be accomplished by first attaching the mounting hardware
to the junction box, making all necessary wiring connections, mounting the fixture to
the wall and then installing the fixture glass.
SAFETY WARNING:
Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
STEP 1
1
Prepare mounting strap (a) by threading long mounting screws (b) into the back
of the mounting strap (a), making sure the holes into which the screws are
threaded match the spacing of holes (d) in the backplate (e) -
See Drawing 1.
2
Attach mounting strap (a) to junction box (j) using two short mounting
screws (c).
3
Make electrical connections from supply wire to fixture lead wires. Refer to
instruction sheet [FRIS18] and follow all instructions to make all necessary
wiring connections. Then refer back to this sheet to continue installation of
this fixture.
4
To mount fixture, slip the two mounting screws (b) through the two mounting
holes (d) in the backplate (e).
5
While holding fixture in place, thread the two ball knobs (f) on to the end of the
mounting screws (b), and tighten.
STEP 2
1
Prior to glass being installed, fixture can now be lamped accordingly.
2
To install glass, slide glass (1) into fixture from the top - see Drawing 2.
[DRAWING 1]
[DRAWING 2]
j
Bulbs:
75W MED.
Replacement Parts:
GLASS: R41612GL
b a
c
e
d f
6.10.09
800.421.3517 WWW.FREDRICKRAMOND.COM
1