Hinkley Lighting VALLEY 4702VK - Manual

assembly instructions
Family: Valley Item No. 4702
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the
main body of the fixture, making all necessary electrical connections and then
mounting the fixture to the ceiling.
start here
4702
1. To assemble main body, thread hex nut (3) on one end of threaded tubing (6)
approximately 1/4” - see Drawing 1.
2. Slip flat washer (4) onto other end of threaded tubing (6) and up against hex nut (3).
3. Slip plastic washer (5) onto threaded tubing (6) and up against flat washer (4).
4. Slip threaded tube (6) through center hole in glass (7).
5. Slip second flat washer (4) onto center stem and hold in position, thread knurl nut (8)
onto end of threaded tubing (6) and tighten against glass (7).
6. Slip spider assembly (9) onto threaded tubing (6).
7. Thread finial (10) onto end of threaded tubing (6) and tighten to secure spider
assembly (9) to glass (7).
8. Line up the holes in the arms of spider assembly (9) with holes in the arms of main
body assembly (1).
9. Thread barrel knob (2) onto end of stud (2A) and then slip through hole (A) in
upright, and thread into hole (B) of spider assembly. Repeat for remaining 2 arms to
secure glass.
10. Fixture can now be lamped accordingly.
Drawing 3 - Fixture Mounting
Drawing 2 - Strap Detail
B
(side view)
gull wing
bracket
B
1
Drawing 1 - Fixture Assembly
10
8
6
4
3
2
A
9
7
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
1.Thread two long 8-32 screws (A) provided into the mounting strap (B). Note: the 2
screws should be threaded into the gull wing shaped part of the mounting strap. With
the flat part of strap facing up. Make sure screws are threaded into holes that line up
with the holes in the canopy (C) - see Drawing 2.
2. Attach mounting strap to junction box with 2 short 8-32 screws (E) provided.
1. Slip canopy of fixture over screws (A) and secure fixture with ball knobs (D) - see
Drawing 3. 5
9.22.10
5
2A
A E
D
C
B
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com