Hinkley Lighting PELHAM 3821 - Manual

assembly instructions
item No. 3821
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction sheet (I.S.
18) and follow all instructions to make all necessary wiring connections.
*** The construction of this fixture will be accomplished by first assembling the main body of
the fixture, installing the mounting bracket, making all necessary wiring connections, mount-
ing the fiture to the ceiling, and then installing the glass.
star t here
3821
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 2 - Fixture Mounting
Drawing 3 - Glass Installation
Drawing 1 - Strap Detail
J
B
A G
D
E
C
1. Prepare mounting strap (B) for mounting by installing screws (A) into mounting plate (B) - see
Drawing 1.
• Be sure the holes into which the screws are threaded match the spacing of holes (C)
in the canopy (1) - see Drawings 1 and 2.
2. Attach mounting plate (B) to junction box (J), using screws (G) provided and slip supply wires
through large center hole.
1. Hang the fixture by slipping canopy (D) over screws (B) and hold in position - see Drawings 1 and
2. Thread ball knobs (E) onto end of screws (B) and tighten to secure fixture to ceiling.
6.1.12
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, Ohio 44012 800-446-5539 www.hinkleylighting.com
1. To install glass, slip center hole of glass (4) onto threaded pin (A), located at the
center of the crossbar (6), see - Drawing 3.
2. Slip rubber washer (3) over threaded pin (A) followed by flat washer (4). Thread
knob (5) onto threaded pin (A) and tighten to secure glass (2).
3. Slip holes in end of crossbar (6) over studs (7) located at the end of arms (1) that
attached to the canopy, and hold glass in position.
4. Fixture can be lamped accordingly at this time.
5. Thread decorative knobs (8) onto studs at end of arm (1) to secure glass to fixture.
1
2
7
5
3
4
6